NGD: 60th Anniversary '58 Jazzmaster

Discussion of newer designs, copies and reissue offset-waist instruments.
Post Reply
User avatar
JamesSGBrown
PAT. # 2.972.923
PAT. # 2.972.923
Posts: 729
Joined: Fri May 04, 2012 1:36 pm
Location: Birmingham, UK

NGD: 60th Anniversary '58 Jazzmaster

Post by JamesSGBrown » Sun Mar 24, 2024 1:29 pm

I remember when these came out, and lusting after one at a music shop in Shrewsbury. So when one become available on another forum I was quite excited (have barely seen them around since they were available new), but sadly it was pickup only and it was a bit far away for me to get to on my single day off per week.

Well, the financial Gods clearly are intent on assisting me in ravaging my bank balance on a consistent basis, because the guy was going to the Northampton Guitar show, which I was working, so after he very kindly put it on hold for me, I now have one!

It's essentially an AV58- flash coat nitro finish, Ash body, 'clay' dots and side markers. From an old thread on here, it seems that though the spec sheet said PV65 pickups, they're actually not (bevelled pole pieces, different bobbin colour, different output). I don't know if they're the same as the AVRI range, or made for this model alone, but I'll tell myself it's the latter to make it all feel a little more special. They sound really good- the neck pickup is outstanding, and after I shimmed the bridge pickup they now balance really well.

It's very, very resonant (as is my AV65 also tbf), and also light (as is my AV65 again), and the neck is bloody wonderful. The Mastery trem and Staytrem bridge really top it all off. I've never been tempted by the Mastery stuff, but it does feel very nice.

I'm fortunate now to own 3 AV65s- JM, Jag and Strat, and a Marrguar which I guess is kinda a AV62 in essence (or 65 w/o binding?), and with this in there now I feel like I've honestly got the best iteration of all of those now. I absolutely love the AV series. I bought this to mark a bit of a personal milestone (1 year off booze and other bad things), so it feels a bit more significant than the usual purchase. Those, along with my '62ri Custom Tele, and 2 very nice nitro Tokai LPs (Silverburst Custom and '56 Goldtop w/ P90s), I genuinely feel like I might actually have no desire to buy anything else for a long while. Thankfully that won't be hard as I'm now broke anyway ha.

Apologies for the shite picture, will get some more soon. It's got a nice amount of wear on it and I look forward to thrashing it even more. Anyone else got one of these?

Image

User avatar
JSett
PAT. # 2.972.923
PAT. # 2.972.923
Posts: 8968
Joined: Mon Jun 01, 2009 1:33 pm
Location: Old Hampshire, Old England

Re: NGD: 60th Anniversary '58 Jazzmaster

Post by JSett » Sun Mar 24, 2024 1:48 pm

This era of vintage reissues really was quite a stunning era for offsets.
Silly Rabbit, don't you know scooped mids are for kids?

User avatar
BoringPostcards
PAT. # 2.972.923
PAT. # 2.972.923
Posts: 7097
Joined: Tue Jun 02, 2009 8:50 am
Location: Newfoundland

Re: NGD: 60th Anniversary '58 Jazzmaster

Post by BoringPostcards » Sun Mar 24, 2024 2:07 pm

I remember when they launched and the horrible GAS.

Call me boring, but that’s the ideal Jazzmaster for me.
One of these days I’ll make a partsmaster to match, or maybe splurge on an FCS version.

You’re very lucky to have found one. Enjoy!
Det er mig der holder traeerne sammen.

User avatar
JamesSGBrown
PAT. # 2.972.923
PAT. # 2.972.923
Posts: 729
Joined: Fri May 04, 2012 1:36 pm
Location: Birmingham, UK

Re: NGD: 60th Anniversary '58 Jazzmaster

Post by JamesSGBrown » Sun Mar 24, 2024 2:11 pm

JSett wrote:
Sun Mar 24, 2024 1:48 pm
This era of vintage reissues really was quite a stunning era for offsets.
Wasn't it just! They all tend to feel like under-the-bed finds or something. True reissues!
BoringPostcards wrote:
Sun Mar 24, 2024 2:07 pm
I remember when they launched and the horrible GAS.

Call me boring, but that’s the ideal Jazzmaster for me.
One of these days I’ll make a partsmaster to match, or maybe splurge on an FCS version.

You’re very lucky to have found one. Enjoy!
It's certainly a nice 'refined' counterpart to my Firemist Silver AV65, which with the WRHBs looks comparatively space-age. I do consider myself very fortunate to have 2 limited run JMs, now I've just gotta hold on to them! Beans for lunch and dinner for a few months I think, and gonna have to skip breakfast altogether...

User avatar
Surfysonic
PAT. # 2.972.923
PAT. # 2.972.923
Posts: 1868
Joined: Sat Dec 04, 2010 12:22 pm
Location: Walkersville, MD
Contact:

Re: NGD: 60th Anniversary '58 Jazzmaster

Post by Surfysonic » Sun Mar 24, 2024 2:23 pm

Congrats! I've GASsed for the 60th Anniversary '58 Jazzmaster for some time. I never could find out what the neck depth @ 1st and 12th frets so I always ended up holding off. How's the neck feel for ya?
The doofus formerly known as Snorre...

User avatar
JamesSGBrown
PAT. # 2.972.923
PAT. # 2.972.923
Posts: 729
Joined: Fri May 04, 2012 1:36 pm
Location: Birmingham, UK

Re: NGD: 60th Anniversary '58 Jazzmaster

Post by JamesSGBrown » Sun Mar 24, 2024 2:30 pm

Surfysonic wrote:
Sun Mar 24, 2024 2:23 pm
Congrats! I've GASsed for the 60th Anniversary '58 Jazzmaster for some time. I never could find out what the neck depth @ 1st and 12th frets so I always ended up holding off. How's the neck feel for ya?
I'll see if I can get some measurements at my Saturday job within the next couple weeks! However, I'd say It's slimmer than my AV65, and both Jags. Maybe between the '62 Tele and Marr, nice and round but not 'big'... now I think about it, very similar to the L-series Jag I had off our Johnny, but slightly wider at the nut.

User avatar
Surfysonic
PAT. # 2.972.923
PAT. # 2.972.923
Posts: 1868
Joined: Sat Dec 04, 2010 12:22 pm
Location: Walkersville, MD
Contact:

Re: NGD: 60th Anniversary '58 Jazzmaster

Post by Surfysonic » Sun Mar 24, 2024 5:01 pm

JamesSGBrown wrote:
Sun Mar 24, 2024 2:30 pm
Surfysonic wrote:
Sun Mar 24, 2024 2:23 pm
Congrats! I've GASsed for the 60th Anniversary '58 Jazzmaster for some time. I never could find out what the neck depth @ 1st and 12th frets so I always ended up holding off. How's the neck feel for ya?
I'll see if I can get some measurements at my Saturday job within the next couple weeks! However, I'd say It's slimmer than my AV65, and both Jags. Maybe between the '62 Tele and Marr, nice and round but not 'big'... now I think about it, very similar to the L-series Jag I had off our Johnny, but slightly wider at the nut.
Nice! Sounds like a good one! Enjoy! 8)
The doofus formerly known as Snorre...

User avatar
Unicorn Warrior
PAT. # 2.972.923
PAT. # 2.972.923
Posts: 3512
Joined: Sun Jul 22, 2012 5:58 pm
Location: Kentucky, USA

Re: NGD: 60th Anniversary '58 Jazzmaster

Post by Unicorn Warrior » Sun Mar 24, 2024 8:38 pm

Congrats. These are great. I remember playing one in a shop a few years ago. I couldn’t justify taking it home and I remember thinking “I’m gonna want one of these when I can’t find them anymore”. And yes..this post reminded me that the time has come

User avatar
Beltone
PAT. # 2.972.923
PAT. # 2.972.923
Posts: 117
Joined: Wed Oct 17, 2018 3:37 pm

Re: NGD: 60th Anniversary '58 Jazzmaster

Post by Beltone » Tue Mar 26, 2024 6:21 pm

Yeah, this one really tempted me when it first came out. Saw 2 at different stores—think only 500 were made—but didn’t try them. Congratulations and enjoy!

User avatar
timtam
PAT. # 2.972.923
PAT. # 2.972.923
Posts: 2746
Joined: Sun Oct 22, 2017 2:42 am
Location: Melbourne

Re: NGD: 60th Anniversary '58 Jazzmaster

Post by timtam » Tue Mar 26, 2024 7:10 pm

Surfysonic wrote:
Sun Mar 24, 2024 2:23 pm
Congrats! I've GASsed for the 60th Anniversary '58 Jazzmaster for some time. I never could find out what the neck depth @ 1st and 12th frets so I always ended up holding off. How's the neck feel for ya?
The specs on the neck (that were probably not published in the service manual until after the guitars had all sold out) are 'Vintage C' with 0.82"/0.90" (20.8/22.9 mm) at 1st/12th frets.
https://www.fmicassets.com/Damroot/Orig ... 3-7-18.pdf

Comparison to other contemporary JM necks (closest to Am Pro and AVII):

Image
"I just knew I wanted to make a sound that was the complete opposite of a Les Paul, and that’s pretty much a Jaguar." Rowland S. Howard.

User avatar
Surfysonic
PAT. # 2.972.923
PAT. # 2.972.923
Posts: 1868
Joined: Sat Dec 04, 2010 12:22 pm
Location: Walkersville, MD
Contact:

Re: NGD: 60th Anniversary '58 Jazzmaster

Post by Surfysonic » Wed Mar 27, 2024 5:23 am

timtam wrote:
Tue Mar 26, 2024 7:10 pm
Surfysonic wrote:
Sun Mar 24, 2024 2:23 pm
Congrats! I've GASsed for the 60th Anniversary '58 Jazzmaster for some time. I never could find out what the neck depth @ 1st and 12th frets so I always ended up holding off. How's the neck feel for ya?
The specs on the neck (that were probably not published in the service manual until after the guitars had all sold out) are 'Vintage C' with 0.82"/0.90" (20.8/22.9 mm) at 1st/12th frets.
https://www.fmicassets.com/Damroot/Orig ... 3-7-18.pdf

Comparison to other contemporary JM necks (closest to Am Pro and AVII):

Image
Thanks! I've got similar neck profiles so that will work. :)
The doofus formerly known as Snorre...

User avatar
bipedal2
PAT PEND
PAT PEND
Posts: 47
Joined: Fri Jan 31, 2020 9:04 am
Location: WMass, USA

Re: NGD: 60th Anniversary '58 Jazzmaster

Post by bipedal2 » Wed Mar 27, 2024 6:26 am

Great-looking guitar, and a fantastic way to celebrate/honor your personal milestone (congrats!). Enjoy.

Post Reply