hey all,
just wondering if anyone has dug into this subject yet. if all the point to point measurements are the same (thimbles to rhythm circuit to pickup routes, etc..)
i can't think of any reason why these 3 models should not be identical?
if anyone knows the answer for sure, hit me up. i am about to start a new wiring project and i was going to source my pickguard from Neagle luthier. for whatever reason, they seem to differentiate between these 3 models.
thanks
has anyone compared the Vintera / AVRI / American Orig pickguard specs?
- tamerofbantha
- PAT. # 2.972.923
- Posts: 70
- Joined: Sat Jun 20, 2020 11:12 am
- peterherman
- PAT. # 2.972.923
- Posts: 1701
- Joined: Thu Jan 08, 2009 7:21 pm
- Location: DC...OK, Arlington.
- Contact:
Re: has anyone compared the Vintera / AVRI / American Orig pickguard specs?
I put a Decoboom pickguard on my Vintera, and the most important holes lined up: pickups, bridge, controls in the right places. Some of the pickguard screws were not in exactly the same place. You may wind up with a similar issue, but I didn't find it to be a dealbreaker.