Page 1 of 1
Switchcraft Toggle Help
Posted: Mon Jan 11, 2021 7:08 pm
by HNB
I got one of these funky toggles that has three outputs instead of the usual two. How do I wire it correctly? I put the neck and bridge in the normal outer two spots and ran the three outputs together but I end up with neckmid/neckmid/bridge.
Re: Switchcraft Toggle Help
Posted: Mon Jan 11, 2021 8:24 pm
by HNB
It looks like if I disconnect A1 but keep b1 and a2 together it should work as normal.
Re: Switchcraft Toggle Help
Posted: Mon Jan 11, 2021 9:29 pm
by Shadoweclipse13
Wow, I've never seen those before. I think a continuity check would solve it, but I have a feeling that I'd still be confused
Re: Switchcraft Toggle Help
Posted: Tue Jan 12, 2021 12:16 am
by timtam
Re: Switchcraft Toggle Help
Posted: Tue Jan 12, 2021 9:25 am
by HNB
Yeah I was dumb and ordered a three way switchcraft right angle toggle and didn't pay enough attention to the picture. LOL
Re: Switchcraft Toggle Help
Posted: Tue Jan 12, 2021 9:36 am
by HNB
I was right. I disconnected that one and they work as it should.
I will post a picture in case someone else gets one of these three leg output toggles by accident.
Re: Switchcraft Toggle Help
Posted: Tue Jan 12, 2021 9:38 am
by HNB
Here it is. That lower left guy needs to not be attached to have it function as a typical three way switch.
2021-01-12_09-37-14 by
Christopher Louck, on Flickr