Here what a WRHB RI looks like from behind (beware of electronic porn):
The thing is splittable, with this mod, that actually requires to solder a few wires on the pickup. But what if I don't want to split it, but would rather want to allow the two coils to be wired either in series or in parallel? Using that schematic, which requires 4 wires.
According to [url=http://]this blueprint[/url], bare (which I assume is soldered to the shielding/cover of the pickup) and brown go to ground, while black is the output. Fine. Looking at the pic above, I'm supposed to cut the white wire to cut the connection between the two coils, right? To make things easier, I'll give those two new wires names:
- top horizontal coil, next to brown: the letter X
- bottom horizontal coil, next to black: Alexander
Which would be wired that way:
Does someone find anything wrong there? Thanks for looking.
I want to be able to wire the coils in parallel rather than in series. Well, "want" is incorrect now, as I've changed my mind. Anyway, the RI are regular HBs in a larger casing, according to I-can't-remember-who; TWOF was probably referring to the original pickup (the link I gave in the previous post was about a RI, and nobody seemed to notice anything wrong).
